DeskProto user forum

In the "Advanced Geometry: Two or more sides, automatic rotation" wizard, on the third page, one can set the milling depth.

I would like to set one milling depth for roughing and a different milling depth for finishing. However, I do not see any settings in the non-wizzard GUI for setting the milling depth.

Would you please show me where the milling depth setting is in the non-wizard GUI?

Thank you.

Hoyt

Lex,

No need to respond to my above question. I now understand that the maximum and minimum Z values can be set in the Area tab.

Perhaps the tab name should be changed to "Volume" in future versions to indicate that X, Y, and Z, can be controlled.

Thank you.

Hoyt

Hi Hoyt,

Happy that you found the solution, and thanks for the suggestion.

Note that in front of each wizard setting you see a small question mark icon. Position the cursor on that question mark and a tooltip will pop up, explaining the setting and also telling you where to find that setting in the non-wizard user interface.
The Help button is available for more information as well.

Success with your project !

Lex.