CONTACT

Delft Spline Systems develops the DeskProto software and sells desktop milling machines from Roland and CPM.

Delft Spline Systems

Address City Postal Code Country Tel Fax Email Internet

Vogelsanglaan 30 Utrecht 3571 ZM The Netherlands +31 30 296 5957 +31 30 296 2292 info@spline.nl http://www.spline.nl

We are registered at the Utrecht Chamber of Commerce, No 30105914

You can find Delft Spline Systems quite easily, both when travelling by car and by public transport. We are located in a district of Utrecht called "Tuindorp Oost", near the highway and with a frequent bus connection to the main railway station. Directions see below.

Routemap.

When arriving by train go to Utrecht Central Station (on the map "Utrecht CS"), and follow the directions to the bus terminal for city transport (so not the regional transport terminal). Locate the stop for Bus Nr 8, direction "Overvecht NS" (so NOT to "Lunetten NS"). A bus will arrive every ten minutes: please board. About 10 to 15 minutes after departure you will cross a large main road with two lanes in each direction, separated by a lawn: the "Kardinaal de Jong weg" At that time press the stop-signal button: the bus will stop after 50 meters to let you out. From there turn left (relative to the direction of the bus) and walk 100 m along the "H. vd Berghlaan". The Vogelsanglaan now is at your left hand, and we are located at the corner.

When arriving by car from any direction except Hilversum, follow the signs 'Hilversum' until you are on highway A27. When coming from Hilversum you are on the A27 already. Take exit No. 30 called "Veemarkt" and turn direction "Veemarkt". After a roundabout (straight ahead) and a railway crossing, at the traffic lights turn right. You now enter a residential quarter. Immediately turn left again: after about 100 m the Vogelsanglaan is at your left hand, and we are located at the corner.